Question
a.
adding the axial load, eccentric load, the product of the bending moment due to eccentric load and the appropriate bending factor
b.
adding the axial load and eccentric load and subtracting the product of bending moment and appropriate bending factor
c.
dividing the sum of axial load and eccentric load by the product of the bending moment and appropirate bending factor
d.
none of these.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. On eccentrically loaded columns, the equivalent axial load may be obtained by
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The distance between the outer faces of flanges of a plate girder, is known as
View solution
Q. Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300 mm or
View solution
Q. Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is
View solution
Q. The effective length of a double angle strut with angles placed back to back and connected to both the sides of a gusset plate, by not less than two rivets, is
View solution
Q. To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
View solution
Q. When the upper column does not provide full bearing area over lower column, the column splice is provided with the following assumption
View solution
Q. For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm² if it is
View solution
Q. The permissible stress to which a structural member can be subjected to, is known as
View solution
Q. Lug angle is
View solution
Q. Effective length of a column effectively held in position and restrained in direction at both ends, is
View solution
Q. A riveted joint many experience
View solution
Q. IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
View solution
Q. The tensile strength of mild steel for bolts and nuts should not be less than
View solution
Q. A riveted joint may experience
View solution
Q. With a percentage increase of carbon in steel, decreases its
View solution
Q. In double lacing, the thickness t of flat lacing is
View solution
Q. The gross section of the web of a beam is defined as
View solution
Q. For simply supported beams, the maximum permitted deflection, is
View solution
Q. In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the grossdiameter of the rivet is 26 mm, the number of rivets required in the splice, is
View solution
Q. Design of a riveted joint, is based on the assumption:
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
