Question
a.
outer end of side drain to outer end of parapet wall
b.
outer end of side drain to inner end of parapet wall
c.
inner end of side drain to outer end of parapet wall
d.
inner end of side drain to inner end of parapet wall
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Formation width of a hill road is the distance between
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. California Bearing Ratio method of designing flexible pavements is more accurate as it involves
View solution
Q. Longitudinal pavement lines marked broken in white paint
View solution
Q. Design of flexible pavement, involves
View solution
Q. Design of highways is based on
View solution
Q. If the designed speed on a circular curve of radius 1400 m is 80 km/hour, no superelevation is provided, if the camber, is
View solution
Q. Width of a rotary round should be equal to
View solution
Q. To prevent movement of moisture from subgrade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is
View solution
Q. The statement, regarding the size of stones used at the wearing surface. "The size of a stone used on a road must be in due proportion to the space occupied by a wheel of ordinary dimensions on a smooth level surface. The point of contact will be found to be longitudinal about 2.5 cm and every piece of stone put into the road which exceeds 2.5 cm in any of its dimension is mischievious" was made by
View solution
Q. If L metres is the distance between extreme axles of a vehicle, its gross load should not exceed
View solution
Q. If V is the design speed of vehicles in km/hour, the change of radial acceleration in metres/sec³, is
View solution
Q. Volume of traffic which is due to improvement carried out in adjacent area, is known as
View solution
Q. Roughness index of roads, is expressed as
View solution
Q. Pick up the correct statement from the following:
View solution
Q. Degree of a road curve is defined as the angle in degrees subtended at the centre by an arc of
View solution
Q. The tangent length of a simple circular curve of radius R deflecting through θ°, is
View solution
Q. Which one of the following transportation systems is not used for the conveyance of passengers in India?
View solution
Q. Thickness of broken line markings on multi-lane road for lanes is generally kept
View solution
Q. On a pavement with parabolic camber, the angle of inclination of the vehicles will be
View solution
Q. The difference in gradients after full super-elevation and the initial alignment of a road, is known as
View solution
Q. If the radius of a main curve is 300 m and length of the transition curve is 100 m, the angle with tangent to locate the junction point, is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!