Q. Longitudinal pavement lines marked broken in white paint

View solution

Q. Design of flexible pavement, involves

View solution

Q. Design of highways is based on

View solution

Q. If the designed speed on a circular curve of radius 1400 m is 80 km/hour, no superelevation is provided, if the camber, is

View solution

Q. Width of a rotary round should be equal to

View solution

Q. To prevent movement of moisture from subgrade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is

View solution

Q. The statement, regarding the size of stones used at the wearing surface. "The size of a stone used on a road must be in due proportion to the space occupied by a wheel of ordinary dimensions on a smooth level surface. The point of contact will be found to be longitudinal about 2.5 cm and every piece of stone put into the road which exceeds 2.5 cm in any of its dimension is mischievious" was made by

View solution

Q. If L metres is the distance between extreme axles of a vehicle, its gross load should not exceed

View solution

Q. If V is the design speed of vehicles in km/hour, the change of radial acceleration in metres/sec³, is

View solution

Q. Volume of traffic which is due to improvement carried out in adjacent area, is known as

View solution

Q. Roughness index of roads, is expressed as

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Degree of a road curve is defined as the angle in degrees subtended at the centre by an arc of

View solution

Q. The tangent length of a simple circular curve of radius R deflecting through θ°, is

View solution

Q. Which one of the following transportation systems is not used for the conveyance of passengers in India?

View solution

Q. Thickness of broken line markings on multi-lane road for lanes is generally kept

View solution

Q. On a pavement with parabolic camber, the angle of inclination of the vehicles will be

View solution

Q. The difference in gradients after full super-elevation and the initial alignment of a road, is known as

View solution

Q. If the radius of a main curve is 300 m and length of the transition curve is 100 m, the angle with tangent to locate the junction point, is

View solution

Q. Minimum radius of a simple circular curve deflecting through 5°, is

View solution