Q. To prevent compressive stresses in a rigid concrete pavement, the joint prvoided, is

View solution

Q. In case of cement concrete pavements, pick up the incorrect statement

View solution

Q. The radius of curvature provided along a transition curve, is

View solution

Q. If a Lemniscate curve of transition throughout is introduced to connect two parallel roads, the maximum polar angle of the curve, is

View solution

Q. If the cross slope of a country is 25% to 60%, the terrain is classified as

View solution

Q. Setting out of Lemniscate transition curves, is done with

View solution

Q. Reference pillars fixed on the centre line of a proposed road, provide the following information:

View solution

Q. The normal road land width for a major district road in open area, is

View solution

Q. Super-elevation on roads in snow bound areas, should generally not exceed

View solution

Q. If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm², spacing of 10 mm tie bars for the longitudinal joint, is

View solution

Q. Minimum number of 50 kg cement bags per cubic metre of concrete for a mix corresponding to crushing strength 280 kg/cm² at 28 days, are

View solution

Q. Three points, A, B and C 500 m apart on a straight road have 500 m, 505 m and 510 m as their reduced levels. The road is said to have

View solution

Q. Non-passing sight distance along a road is the longest distance at which the driver of a moving vehicle, may see an obstacle on the pavement

View solution

Q. The minimum road width is taken

View solution

Q. If cross slope of a country is upto 10% the terain is classified as

View solution

Q. When each particle of aggregates is thinly coated with cement paste, a heterogeneous solid is formed, which is known as

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. If the width of carriage way is 12.5 metres, outer edge 50 cm higher than the inner edge, the required super elevation is

View solution

Q. In cement concrete pavements, tensile stress is due to :

View solution

Q. If L is the length of the transition curves provided on either side of a circular curve of radius R, the maximum angle of deflection with tangent for the junctions of the transition curve and circular curve, is

View solution