Q. When each particle of aggregates is thinly coated with cement paste, a heterogeneous solid is formed, which is known as

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. If the width of carriage way is 12.5 metres, outer edge 50 cm higher than the inner edge, the required super elevation is

View solution

Q. In cement concrete pavements, tensile stress is due to :

View solution

Q. If L is the length of the transition curves provided on either side of a circular curve of radius R, the maximum angle of deflection with tangent for the junctions of the transition curve and circular curve, is

View solution

Q. Interior thickness of concrete road slab for design wheel load 6300 kg and permissible flexural stress 21 kg/cm², is

View solution

Q. In a braking test, a vehicle travelling at 36 km ph was stopped at a braking distance of 8.0 m. The average value of the vehicle's skid resistance (friction coefficient) is

View solution

Q. If present A.D.T. is 5000 vehicles and annual increase is 10%, the average future flow after 5 years will be

View solution

Q. To prevent a head-on-collision of vehicles travelling in opposite directions along four-lane roads

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The G.T. road from Lahore to Calcutta in undivided India, was constructed during

View solution

Q. The gradients of trace cuts for hilly roads, are kept

View solution

Q. The width of the right of way in urban area, is kept between 24 m to 60 m for

View solution

Q. If the rate of change of the super-elevation along a curved portion of a 7 metre wide road is 1 in 150 and the maximum super-elevation allowed is 1 in 15, the maximum length of the transition curve to be provided at either end, is

View solution

Q. The full width of land acquired before finalising a highway, alignment is known

View solution

Q. Indian Road Congress (I.R.C.) was founded and constituted with its head quarters at New Delhi, in

View solution

Q. Extra widening required at a horizontal curve on a single lane hill road of radius 80 m for a design speed of 50 km ph and for a vehicle with wheel base 6.0 m is

View solution

Q. The normal road land width for a National or State highway, in open areas should be

View solution

Q. Excessive camber on pavements may cause

View solution

Q. The type of curves generally provided on highways, is

View solution