Q. The distance between, rivet line and the nearest edge of a joint not exposed to weather, is taken (where t is thickness in mm of the thinner outside plate).

View solution

Q. For design of a column the eccentricity of loading shall be taken as the distance from the assumed point of application of the load to the centroid of the column, subject to a minimum of

View solution

Q. The concrete is deemed not to comply with the strength requirements if the strength is less than the greater of

View solution

Q. For heavily reinforced concrete member, the nominal maximum size of the aggregates should be restricted to

View solution

Q. The minimum pitch i.e., the distance between centres of rivet holes is not less than

View solution

Q. Dispersion of load through the flange to web is considered as dispersed uniformly at an angle θ° is

View solution

Q. The grade of concrete generally not used in the reinforced concrete, is

View solution

Q. The outstand of stiffeners should be (where t is the thickness of flat).

View solution

Q. The maximum area of compression reinforcement in a beam of cross section B x D is limited to

View solution

Q. Moist curing of the exposed surfaces of concrete is done at least for

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. If the ratio of effective span to overall depth of a simply supported beam is equal or greater than 1 but less than or equal to 2, the lever arm, is

View solution

Q. If the slenderness ratio of a column is more than 160, the compressive stress obtained by the secant formula is multiplied by a factor (x - 1/800r) in which value of x is

View solution

Q. The slenderness ratio of single angle discontinuous struts conmected by a single rivet or bolt, shall not exceed

View solution

Q. In adverse circumtances, the reinforced concrete member immersed in sea water or subjected to sea spray, the maximum permissible cover for the reinforcing bars, should not exceed

View solution

Q. If a column is subjected to dead load and super imposed load only, the maximum ratio 1/r should not be greater than

View solution

Q. If the dimensions of a rectangular section of a short column are 15 cm x 20 cm, its unsupported length should be restricted to

View solution

Q. For battened struts, the effective length is increased by

View solution

Q. The maximum horizontal deflection of a column of actual length L, when subjected to lateral forces, may be upto

View solution

Q. The test strength of the sample is taken as the average of the strength of

View solution