Q. For the proportions

View solution

Q. Columns are designed for a minimum eccentricity equal to 1/30 (unsupported length ofthe column), subject to a minimum of

View solution

Q. If fck is the characteristic cube strength of concrete in N/mm², the modulus of elasticity of structural concrete Ec = a√fck where the value of a, is

View solution

Q. The effective depth of a shallow beam is the distance between

View solution

Q. The minimum area of cross section of reinforcement in either direction of a slab should not be less than ...... of the slab cross section

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Pick up the correct statement for the web stiffeners.

View solution

Q. The structure which is subjected to an imposed load after 72 hours for a period of 24 hours, is deemed to be unacceptable if it fails to recover the net deflection less than

View solution

Q. The pitch of transverse reinforcement of a column is taken as

View solution

Q. The pH value of water to be used in concrete shall generally be

View solution

Q. Pick up the correct statement applicable to cased columns.

View solution

Q. Creep of concrete is assumed proportional to the stress if the stress does not exceed .......of the characteristic compressive strength

View solution

Q. The characteristic strength of concrete is the strength of material if its test result is not less than

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The minimum length of the side or diameter of the column base shall not be less than (where d is the minimum diameter of the column).

View solution

Q. For design purpose, the moment at the support where two unequal spans or spans not equally loaded meet, is

View solution

Q. As per IS : 800-1982, the coefficient of expansion for steel per degree centigrade per unit length, is

View solution

Q. The flat slab is a reinforced concrete slab with or without drops and is supported

View solution

Q. The ratio of the effective length to the least radius of gyration of a tie member of a roof truss, which gets subjected to reversal of stress shall not exceed

View solution

Q. For deformed reinforcing bars, the permissible design bond stress may be increased by

View solution