Q. As per IS : 800-1982, the coefficient of expansion for steel per degree centigrade per unit length, is

View solution

Q. The flat slab is a reinforced concrete slab with or without drops and is supported

View solution

Q. The ratio of the effective length to the least radius of gyration of a tie member of a roof truss, which gets subjected to reversal of stress shall not exceed

View solution

Q. For deformed reinforcing bars, the permissible design bond stress may be increased by

View solution

Q. The maximum pitch of rivets for compression and tension members should not exceed

View solution

Q. Minimum diameter of the lateral ties should not be less than

View solution

Q. The ratio of the effective lengths of two columns, one effectively held in position at one end and partially restrained at the other end, and the other effectively held in position at one end and free at the other end, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The minimum thickness of the web plate for a crane gantry plate girder with a lifting load exceeding 15 tonnes, is

View solution

Q. The greater clear dimension of web of thickness't' should not exceed

View solution

Q. For under water concreting.

View solution

Q. The actual length of a column provided with a cap and base, is the distance between

View solution

Q. The maximum bending moment in a purlin of length L when subjected to a distributed load ω, is assumed

View solution

Q. A column of rectangular section is considered short, if both the slenderness ratios are less than

View solution

Q. The tolerances for the form work of columns and beams range from

View solution

Q. The effective length of lacing is the distance

View solution

Q. M 30 grade concrete means, its compressive strength of 15-cm cube, is 30 N/mm² after

View solution

Q. If the ratio of effective span to overall depth of a simply supported beam is less than 1, the lever arm is

View solution

Q. If the ends of the compression flanges of simply supported girders are fully restrained against lateral bending, the effective length is taken as

View solution

Q. The individual part of the structures is subjected to a load test for 24 hours by applying a load equal to full dead load of the structure plus

View solution