Question
a.
40
b.
60
c.
0
d.
100
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In figure V is ideal voltmeter having infinite resistance. It will read __________ volt.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The equivalent inductance seen at terminals A - B is
View solution
Q. For the R-L circuit shown in the figure, the input voltage vi(t) = U(t). The current i(t) is
View solution
Q. A parallel plate capacitor has plate area A and distance between the plates is d. It has two dielectrics each of thickness d and area 0.5 A. The dielectric constants are ∈1 and ∈2. The total capacitance is given by the equation
View solution
Q. Which of the following theorems can be conveniently used to find power consumed in 10 Ω resistor in figure?
View solution
Q. In the circuit of figure is
View solution
Q. The VTH at terminals A and B is equal to
View solution
Q. The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistance is
View solution
Q. In the circuit of figure the current through 5 Ω resistance at t = ∞ is
View solution
Q. In an infinite ladder Ckt as shown above each resistance of rΩ then RAB
View solution
Q. The admittance parameter Y12 in the 2 port network in the figure
View solution
Q. The differential equation for the current i(t) in the Ckt is
View solution
Q. The low pass filter characteristic shown in figure realizable.
View solution
Q. The filter in figure, uses ideal op-amp. It is
View solution
Q. For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average value is
View solution
Q. Figure shows an R-L circuit. The current is i = 1 - e^(-t). The rate of change of current at t = 1 second is
View solution
Q. The time constant of the circuit after the switch shown in the figure is opened is
View solution
Q. Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements are
View solution
Q. The equivalent resistance between terminals x and y figure
View solution
Q. Find Vth in the circuit
View solution
Q. The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figure is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!