Q. DC voltage of the order of a few mV can be accurately of measured by

View solution

Q. In a CE amplifier the input impedance is equal to the ratio of

View solution

Q. For a system to work, as oscillator the total phase shift of the loop gain must be equal to

View solution

Q. An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a

View solution

Q. To prevent a DC return between source and load, it is necessary to use

View solution

Q. For a base current of 10 μA, what is the value of collector current in common emitter if βdc = 100

View solution

Q. Which of the following oscillators is suitable for frequencies in the range of mega hertz?

View solution

Q. Consider the following statements : A clamper circuit

1. adds or subtracts a dc voltage to a waveform
2. does not change the waveform
3. amplifiers the waveform

Which are correct?

View solution

Q. A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that

View solution

Q. Which power amplifier can deliver maximum load power?

View solution

Q. The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when

View solution

Q. An exponential amplifier has diode in feedback path.

View solution

Q. DC amplifiers have a tendency to be unstable.

View solution

Q. A half wave diode rectifier has a capacitance input filter. If input voltage is Vm sin ωt, PIV is

View solution

Q. An amplifier with loop gain Aβ will be more stable for value of Aβ as

View solution

Q. A CB amplifier has re = 6 Ω, RL = 600 Ω and a = 0.98. The voltage gain is

View solution

Q. A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is RL and filter capacitance is C. For good output wave shape, the time constant RLC should be at least equal to

View solution

Q. In class C operation of an amplifier circuit, the collector current exists for

View solution

Q. In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit

View solution

Q. To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use

View solution