Q. Bus bars are always meant for very heavy currents.

View solution

Q. A low-pass filter frequency responce H (jω) = A (ω) e^(jΦ) (ω) does not produce any phase distortion, if

View solution

Q. In a tungsten filament lamp

View solution

Q. An RLC series circuit has R = 8 Ω, XL = 8 Ω and XC = 8 Ω Its impedance is

View solution

Q. Two similar mutually coupled coils have a total inductance of 900 mH and coefficient of coupling 0.5. The self inductance of each coils is

View solution

Q. For a high pass filter attenuation = 0 at f = 0.

View solution

Q. Two voltages are v1= 100 sin (ωt + 15°) and v2 = 60 cosωt, then

View solution

Q. If A = 16 ∠64°, (A)^0.5 is

View solution

Q. One commercial unit of energy is equal to

View solution

Q. Two coupled coils with self inductances of 4 mH and 16 mH are connected in series. The maximum possible value of inductance can be

View solution

Q. In using KCL it is necessary that current leaving a node is written as negative.

View solution

Q. A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is

View solution

Q. If Z(s) has a pole at origin, the realization leads to

View solution

Q. A series resonant circuit has inductance L. If L is increased, the resonant frequency

View solution

Q. In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is

View solution

Q. If absolute potential of A is - 8 V and that of B is - 16 V, VAB is equal to

View solution

Q. An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, XL = 50 Ω, XC is

View solution

Q. For a given voltage four heating coils will give maximum heat when connected

View solution

Q. A system defined by dy/dt + y = x is initially at rest, and x = u(t) sin 2t then the forced response is K sin (2t - θ). The value of θ given by

View solution

Q. A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance

View solution