Question
a.
direction of current through the resistor
b.
direction and magnitude of current through the resistor
c.
direction and magnitude of current and value of resistance
d.
magnitude of current through the resistance
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. To determine the polarity of voltage drop across a resistor, it is sufficient to know
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A sawtooth current wave is passed through a resistance
View solution
Q. Which of the following is the poorest conductor of electricity?
View solution
Q. The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
View solution
Q. An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
View solution
Q. If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor.
View solution
Q. If V = 100 ∠ 16°, the √(V) is
View solution
Q. In an underdamped RLC series circuit, the natural frequency is ωn. The frequency of damped oscillations is
View solution
Q. A dc network has 3 independent nodes and 4 loops. In total analysis, the number of equations is
View solution
Q. A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
View solution
Q. The pole of a reactive function
View solution
Q. Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
View solution
Q. A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
View solution
Q. The strength of controlled voltage source depends on
View solution
Q. A band elimination constant k filter has series resonant circuit in series arms.
View solution
Q. If e = 110 sin (ωt + π/3) and i = 5 sin (ωt - π/3), the impedance of the circuit is
View solution
Q. Two sinusoidal waves 1 and 2 have peak values Vm1 and Vm². Wave 1 is leading wave 2 by ∠θ. Which of the following is correct?
View solution
Q. Ohm's law is valid for
View solution
Q. In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
View solution
Q. Stray capacitance is important at low frequencies.
View solution
Q. A non-linear element has zero resistance.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!