Question

A sawtooth current wave is passed through a resistance

a.

the waveshapes of voltages across resistance and power will also the sawtooth

b.

the waveshape of voltage across resistance will be sawtooth

c.

the waveshape of power will be sawtooth

d.

neither the voltage waveshape nor power wave-shape will be sawtooth

Answer: (b).the waveshape of voltage across resistance will be sawtooth

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A sawtooth current wave is passed through a resistance

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which of the following is the poorest conductor of electricity?

Q. The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .

Q. An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is

Q. If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor.

Q. If V = 100 ∠ 16°, the √(V) is

Q. In an underdamped RLC series circuit, the natural frequency is ωn. The frequency of damped oscillations is

Q. A dc network has 3 independent nodes and 4 loops. In total analysis, the number of equations is

Q. A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum

Q. The pole of a reactive function

Q. Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.

Q. A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be

Q. The strength of controlled voltage source depends on

Q. A band elimination constant k filter has series resonant circuit in series arms.

Q. If e = 110 sin (ωt + π/3) and i = 5 sin (ωt - π/3), the impedance of the circuit is

Q. Two sinusoidal waves 1 and 2 have peak values Vm1 and Vm². Wave 1 is leading wave 2 by ∠θ. Which of the following is correct?

Q. Ohm's law is valid for

Q. In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been

Q. Stray capacitance is important at low frequencies.

Q. A non-linear element has zero resistance.

Q. In a RL circuit, the angle, θ by which the current lags the voltage is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!