Question

In a RL circuit, the angle, θ by which the current lags the voltage is

a.

0 > θ > - 90°

b.

90°

c.

d.

0 < θ < 90°

Answer: (d).0 < θ < 90°

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a RL circuit, the angle, θ by which the current lags the voltage is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): The Laplace transform of a ramp is 1/s².

Reason (R): The integral of a unit step function gives an impulse function.

Q. A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be

Q. A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be

Q. A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is

Q. In an ideal current source, the source resistance is zero.

Q. A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is

Q. Two capacitors of 1 μF and 2 μF are connected in series across a 10 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be

Q. A series RLC circuit has Q = 5. A voltage of 10 V rms is applied to it. At resonance, the voltage across C is

Q. A capacitor having capacitance C is raised to voltage V. The energy stored will be

Q. In an R-L circuit, the impedance is 30 Ω at a frequency of 100 Hz. At 200 Hz, the impedance should be

Q. The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.

Q. Two phasors having rms values V1 and V2 which are added to give a phasor having rms value V3. V3 is maximum if phase angle between V1 and V2 is

Q. A current of 1 A in the coil of an iron cored electromagnet cause a flux density of 0.2.T. If the current is 2 A, B=

Q. In a practical current source, the load current

Q. A resistor R of 1 Ω and two inductor L1 and L2 of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L1 and L2 are 1 A and 2 A, respectively. The current through R at time t = ∞ will be

Q. A 10 ohm resistance and a 10 ohm capacitor are connected in series across a 100 V ac supply. The rms voltage across resistance is

Q. When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications

Q. An m derived low pass filter has fc = 1000 Hz and m = 0.6. This filter will have infinite attenuation at

Q. A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is

Q. If operator 'a' = 1 ∠120° then (1 + a) =

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!