Question
a.
30 Ω or more
b.
60 Ω or more
c.
15 Ω or less
d.
more than 30 Ω but less than 60 Ω
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In an R-L circuit, the impedance is 30 Ω at a frequency of 100 Hz. At 200 Hz, the impedance should be
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
View solution
Q. Two phasors having rms values V1 and V2 which are added to give a phasor having rms value V3. V3 is maximum if phase angle between V1 and V2 is
View solution
Q. A current of 1 A in the coil of an iron cored electromagnet cause a flux density of 0.2.T. If the current is 2 A, B=
View solution
Q. In a practical current source, the load current
View solution
Q. A resistor R of 1 Ω and two inductor L1 and L2 of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L1 and L2 are 1 A and 2 A, respectively. The current through R at time t = ∞ will be
View solution
Q. A 10 ohm resistance and a 10 ohm capacitor are connected in series across a 100 V ac supply. The rms voltage across resistance is
View solution
Q. When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
View solution
Q. An m derived low pass filter has fc = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
View solution
Q. A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
View solution
Q. If operator 'a' = 1 ∠120° then (1 + a) =
View solution
Q. A current wave is i = 100e^(-60t) The initial and final values of current are
View solution
Q. Assertion (A): The impedance of a series resonant circuit is minimum at resonance.
Reason (R): Resonance condition implies unity power factor condition.
View solution
Q. The internal impedance of a source is 3 + j 4 Ω. It is desired to supply maximum power to a resistive load. The load resistance should be
View solution
Q. The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be
View solution
Q. A wave trap is a
View solution
Q. In an ac series RLC circuit the maximum phase difference between any two voltages can be
View solution
Q. In a series circuit with XL constant and R variable the current locus lies in the third quadrant.
View solution
Q. One coulomb charge is equal to the charge on
View solution
Q. Two capacitors of 16 μF each are connected in series. Another capacitor of 16 μF is connected in parallel with this combination. The total capacitance will be
View solution
Q. Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.
Reason (R): Operator 'a' has a value 1 ∠ 120°.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!