Question

In terms of z parameters, the condition for the network to be passive is

a.

z11 = z22

b.

z12 = z21

c.

z11 = 0

d.

z22 = 0

Answer: (b).z12 = z21

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In terms of z parameters, the condition for the network to be passive is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Among the filter, Bessel, Butterworth and chebyshev, the filter with maximally flat response is

Q. If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to

Q. In a driving point function poles and zeros must be conjugate if complex or imaginary.

Q. The storage battery used in power stations and substations is generally

Q. For an m-derived filter, attenuation is infinite when f = f∞.

Q. Assertion (A): A branch with no current through it can be replaced by an open circuit or short circuit.

Reason (R): Reciprocity theorem is applicable only if the circuit has one source.

Q. Three capacitors each 9 μF are connected in delta. The value of each capacitor in equivalent star connection is

Q. The function is

Q. The electrolyte in nickel cadmium cell is dilute potassium hydroxide.

Q. In a circuit containing a complex impedance, maximum power transfer takes place when load is

Q. The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about

Q. For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.

Q. A reactance function is always a quotient of

Q. An ideal voltage source can not be converted into an equivalent current source.

Q. I = dq/dt.

Q. A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be

Q. A constant k high pass filter has fc = 3000 Hz. At f = 1000 Hz, the phase shift is

Q. For an RC impedance function Z

Q. The two port networks are connected in cascade, the combination is to be represented as a single two-Port network. The parameters of the network are obtained by multiplying the individual matrix

Q. Which one of the following statements is not a property of RL driving point impedance?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!