Q. The relative permeability of an iron specimen is 400 when B = 0.2 T. If B = 0.4 T, μᵣ will be

View solution

Q. When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).

View solution

Q. The transient currents are due to

View solution

Q. When a lead acid cell is in fully charged condition the specific gravity of electrolyte is about 1.22.

View solution

Q. In ZRC(s) has a pole at s = 0, the first element in first Foster realization is

View solution

Q. The sum of positive real function is positive real.

View solution

Q. Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

View solution

Q. For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives

View solution

Q. The time constant of the capacitance circuit is defined as the time during which voltage

View solution

Q. In drawing phasor diagram

View solution

Q. As the number SWG increases, area of cross-section decreases.

View solution

Q. In ZRC (s) has a pole at s = ∞, the last element in first Foster realization is

View solution

Q. An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis

View solution

Q. Two port Z parameter not exist for the circuit if

View solution

Q. For a reactance function H(s), the slope dH (jω)/dω is

View solution

Q. Which is correct for a driving point function?

View solution

Q. The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.

View solution

Q. How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?

View solution

Q. In a series R-L-C circuit, the voltage across inductance will be maximum

View solution

Q. Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

View solution