Question

In drawing phasor diagram

a.

rms values are used

b.

peak values are used

c.

either rms or peak values are used

d.

either rms or peak or averages values are used

Answer: (a).rms values are used

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In drawing phasor diagram

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. As the number SWG increases, area of cross-section decreases.

Q. In ZRC (s) has a pole at s = ∞, the last element in first Foster realization is

Q. An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis

Q. Two port Z parameter not exist for the circuit if

Q. For a reactance function H(s), the slope dH (jω)/dω is

Q. Which is correct for a driving point function?

Q. The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.

Q. How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?

Q. In a series R-L-C circuit, the voltage across inductance will be maximum

Q. Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Q. Millman's theorem is the best to find

Q. The transfer function s/(s+a) is for

Q. The units of resistivity are ohm-metre.

Q. A n-port network is said to be active if power in the ckt is __________ .

Q. When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.

Q. Transformer coil is an insulator.

Q. Assertion (A): An impulse has very high magnitude but very small duration.

Reason (R): A pulse function is always rectangular.

Q. The active elements on the positive and negative plates of lead acid battery are:

Q. For a symmetrical network

Q. Consider the following statements:

1. Tellegen's theorem is applicable to any lumped network.
2. Reciprocity theorem is applicable to linear bilateral network.
3. Thevenin theorem is applicable to two terminal linear active network.
4. Norton's theorem is applicable to linear active network.

Which of the above statements are correct?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!