Q. In two wattmeter method of 3 phase power measurement, when does one wattmeter read negative

View solution

Q. It is required to measure angular position. Out of the transducers

1.Circular potentiometer
2. LVDT
3. E pick up
4. Synchro

The proper devices are

View solution

Q. To increase Q factor of a coil, the wire should be

View solution

Q. An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is

View solution

Q. The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be

View solution

Q. In 3 phase power measurement by two wattmeter method, the reading of one wattmeter is zero. The power factor of load is

View solution

Q. In a CRO which of the following is not a part of electron gun

View solution

Q. In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is

View solution

Q. Two resistors R1 = 36 Ω ± 5% and R2 = 75 Ω ± 5% are connected in series. The total resistance is

View solution

Q. In a strain measuring device using a strain gauge, the output quantity is

View solution

Q. A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be

View solution

Q. A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is

View solution

Q. An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is

View solution

Q. Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

View solution

Q. As per BIS there are 6 accuracy classes of instruments.

View solution

Q. If reference sound pressure P₀ is 2 x 10¯⁵ N/m², a sound pressure of 90 dB is equal to

View solution

Q. Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?

View solution

Q. A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make

View solution

Q. Assertion (A): De sauty's bridge is suitable only for pure capacitor.

Reason (R): Capacitors are mostly perfect.

View solution

Q. In which of the transformer is the secondary nearly short circuited under normal operating conditions?

View solution