Q. Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?

View solution

Q. A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make

View solution

Q. Assertion (A): De sauty's bridge is suitable only for pure capacitor.

Reason (R): Capacitors are mostly perfect.

View solution

Q. In which of the transformer is the secondary nearly short circuited under normal operating conditions?

View solution

Q. The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X-plate input is 2 sin ωt, the Y-plate input is

View solution

Q. The angle δ for a mica capacitor is about

View solution

Q. A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is

View solution

Q. The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10¯⁶ N-m on full scale. If B = 1 Wb/m², range of meter is

View solution

Q. Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

1. mismatch between FET parameters
2. difference in values of resistances used in circuit
3. variation in supply voltage.

Of the statements, the correct statements are

View solution

Q. A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be

View solution

Q. Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because

View solution

Q. Assertion (A): A hot wire ammeter has a cramped scale.

Reason (R): The heat is proportional to square of current.

View solution

Q. Which of the following is true about an impulse voltage?

View solution

Q. Which of the following are needed both for protection and metering?

View solution

Q. A digital frequency counter can be converted to DVM by addition of a suitable

View solution

Q. A dynamometer wattmeter is connected in ac circuit. The reading will be

View solution

Q. The speed transducer using a drag cup rotor has the main advantage of

View solution

Q. A voltmeter using thermocouples measures

View solution

Q. Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?

View solution

Q. Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?

View solution