Q. Electrostatic voltmeter is suitable only for low voltages.

View solution

Q. An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is

View solution

Q. If an inductance L is connected in one arm of bridge and resistance R1, R2, R3 in other three arms

View solution

Q. A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be

View solution

Q. A single element strain gauge bridge has two fixed resistances R1 and R1 of 120 Ω each and a variable resistance which gives full deflection at 120 Ω for zero strain and 120.6 Ω for straine e. If gauge factor is 2, strain e is

View solution

Q. If eddy current damping is to be used, the disc of instrument should be

View solution

Q. The scale of moving iron instrument is linear.

View solution

Q. With a variable reluctance tachometer having 60 rotor teeth the count reads 3600 counts per minute. The speed in RPM is

View solution

Q. When measuring phase angle between two waves using a CRO, the time base generator is connected to

View solution

Q. It is required that a strain gauge has gauge factor of 100. The proper strain gauge is

View solution

Q. LVDT is a

View solution

Q. A 0-200 V voltmeter has an accuracy of 0.75% of full scale reading. If voltage measured is 100 V, the error is

View solution

Q. In Schering bridge, the potential of detector above earth potential is about

View solution

Q. Which of the following instruments has non-linear scale?

1. Moving coil instrument
2. Moving iron instrument
3. Electrostatic instrument
4. Rectifier instrument

Select the answer as per following codes

View solution

Q. Kelvin's double bridge is used to measure low resistances because

View solution

Q. Assertion (A): Shunt of an ammeter has a low resistance.

Reason (R): Shunt may be connected in series or in parallel with ammeter.

View solution

Q. The scale of hot wire instrument is linear.

View solution

Q. The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a

View solution

Q. The resistance of a 125 Ω strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is

View solution

Q. A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about

View solution