Q. Panel instruments are generally mounted vertically.

View solution

Q. Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

View solution

Q. A generated voltage is equally dependent on three resistances R1, R2, R3 and its value is V = (R1R2)/R3. If tolerance of each resistor is 0.1%, the maximum error in voltage is

View solution

Q. Assertion (A): A thermocouple transducer is based on Seeback effect.

Reason (R): In a thermocouple transducer used for temperature measurement, the cold junction is usually kept in ice bath.

View solution

Q. In an Anderson bridge the unknown inductance is measured in terms of

View solution

Q. In a Ballistic galvanometer

View solution

Q. Which instrument needs creep compensation?

View solution

Q. For use at 50 Hz the range of scale of vibrating reed frequency meter is

View solution

Q. Consider the following statements about a moving iron instrument

1. It is an unpolarised instrument.
2. It has permanent magnet.
3. It has a fixed coil.
4. It has two iron vanes.

Of these statements

View solution

Q. The two pressure coils in a single phase power factor meter of turns

View solution

Q. Piezoelectric effect can be used to measure

View solution

Q. A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is

View solution

Q. A current of 3.25 A is flowing through a resistance of 34.98 Ω. The voltage drop across resistance to the appropriate number of significant figures is

View solution

Q. The braking torque in single phase energy meter is proportional to speed of disc.

View solution

Q. To measure a resistance by a dc potentiometer

View solution

Q. In dc tacho generators used for measurement of speed of shaft, frequent calibration is necessary because

View solution

Q. A multimeter can be used as ohmmeter.

View solution

Q. A voltage of about 200 V dc can be measured

View solution

Q. In a low power factor wattmeter, compensation for pressure coil current is provided.

View solution

Q. De Sauty bridge is very widely used due to

View solution