Q. Watthour meter is an integrating instrument

View solution

Q. An ammeter is

View solution

Q. It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is

View solution

Q. Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

View solution

Q. In portable instruments, damping is provided by

View solution

Q. The sensitivity of electromagnetic digital flow meter can be increased by increasing

View solution

Q. The increase in intensity of trace in a CRO causes a change in

View solution

Q. A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be

View solution

Q. The resistance of voltmeter affects the accuracy of measurement in loss of charge method.

View solution

Q. In a hot wire instrument, the deflection is proportional to

View solution

Q. A permanent magnet moving coil meter can be used as

View solution

Q. If temperature increases by about 50°, the resistance of thermistor changes to

View solution

Q. Which of the following draws minimum power from source?

View solution

Q. The range of RTD using platinum is about

View solution

Q. A digital voltmeter has a 4 1/2 digit display. The 1 V range can measure voltage up to

View solution

Q. Consider the following statements as regards induction and dynamometer wattmeters

1. Dynamometer wattmeters can be used for dc only.
2. Induction wattmeter has higher torque and dynamometer wattmeter.
3. Induction wattmeter is less accurate, has more power consumption and more weight than dynamometer wattmeter.

Which of the above statements are correct?

View solution

Q. A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.

View solution

Q. For a current transformer, the standard secondary rating is

View solution

Q. To avoid the effect of stray magnetic fields in ac bridge we can use

View solution

Q. A resistance strain gauge is usually

View solution