Q. The increase in intensity of trace in a CRO causes a change in

View solution

Q. A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be

View solution

Q. The resistance of voltmeter affects the accuracy of measurement in loss of charge method.

View solution

Q. In a hot wire instrument, the deflection is proportional to

View solution

Q. A permanent magnet moving coil meter can be used as

View solution

Q. If temperature increases by about 50°, the resistance of thermistor changes to

View solution

Q. Which of the following draws minimum power from source?

View solution

Q. The range of RTD using platinum is about

View solution

Q. A digital voltmeter has a 4 1/2 digit display. The 1 V range can measure voltage up to

View solution

Q. Consider the following statements as regards induction and dynamometer wattmeters

1. Dynamometer wattmeters can be used for dc only.
2. Induction wattmeter has higher torque and dynamometer wattmeter.
3. Induction wattmeter is less accurate, has more power consumption and more weight than dynamometer wattmeter.

Which of the above statements are correct?

View solution

Q. A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.

View solution

Q. For a current transformer, the standard secondary rating is

View solution

Q. To avoid the effect of stray magnetic fields in ac bridge we can use

View solution

Q. A resistance strain gauge is usually

View solution

Q. Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

View solution

Q. In ac bridge measurements, 'Wagner ground' means

View solution

Q. In a platinum RTD, the change in resistance for a temperature rise of 50° C is about

View solution

Q. The gauge factor of a semiconductor strain gauge is about

View solution

Q. Which of the following instruments is used almost exclusively to measure radio frequency currents?

View solution

Q. The coil of a DArsonval galvanometer has N turns. If flux density is B, current is I and area of coil is A, the deflecting torque is

View solution