Q. Consider the following statements regarding electromagnetic flowmeter

1. AC excitation is used to avoid polarisation of fluid.
2. The meter calibration is changed as viscosity of fluid changes.
3. Stainless steel pipes can be used for measuring the flow of liquid of high conductivity.

Of the above statements

View solution

Q. Pirani gauge is used to measure

View solution

Q. Assertion (A): CRT is the most important component of a CRO.

Reason (R): When an electron beam strikes the screen of CRT, a spot of light is produced.

View solution

Q. A capacitance transducer has two plates each of area 5 mm². The coil gap is 2 mm. Displacement sensitivity due to change in gap length is

View solution

Q. Four capacitors are in parallel. Their values are 36.3 μF, 3.85 μF, 34.002 μF and 850 μF with an uncertainty of digit in the last place. The total capacitance in significant figures is

View solution

Q. In a single phase power factor meter the phase difference between currents in the two pressure coils is

View solution

Q. In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be

View solution

Q. Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that

View solution

Q. In order to achieve accuracy, the slide wire of a potentiometer should be

View solution

Q. In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.

View solution

Q. A permanent magnet moving coil measures

View solution

Q. A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then

View solution

Q. In measurements using strain gauge, the dummy strain gauge is used to

View solution

Q. In an ac single phase energy meter, the potential coil is put on

View solution

Q. The chemical effect of current is used in

View solution

Q. The switch board instruments

View solution

Q. Radiation pyrometer is used to measure temperature in the range of

View solution

Q. The electromagnets of an induction wattmeter

View solution

Q. In a vibrating reed frequency meter the natural frequency of two adjacent reeds have a difference of

View solution

Q. In a CRO, the time base signal is applied to

View solution