Q. Consider the following statements regarding electro-dynamometer type indicating instrument It can be used for measuring

1. Direct current
2. Alternating current
3. Direct voltage
4. Alternating voltage

Of these statements

View solution

Q. The advantage of LVDT over inductive bridge type transducer is that

View solution

Q. In a Weston synchronoscope the deflecting torque is zero when

View solution

Q. Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

View solution

Q. Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

View solution

Q. Assertion (A): A radiation pyrometer is very suitable for high temperature measurement.

Reason (R): When temperature is high, a physical contact between hot body and thermometer is not desirable.

View solution

Q. Burden of an instrument transformer is expressed in

View solution

Q. Which of the following devices should be used for accurate measurement of a low dc voltage?

View solution

Q. An electrodynamometer instrument has the advantage of

View solution

Q. The dimensions of permittivity are

View solution

Q. It is required to measure a low magnitude high frequency current. The proper instrument is

View solution

Q. Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain

View solution

Q. The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a

View solution

Q. The sensitivity of a potentiometer can be increased by

View solution

Q. Two resistances are R1 = 36 ± 5% and R2 = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be

View solution

Q. An ac bridge uses galvanometer as detector.

View solution

Q. Consider the following statements about mutual inductances:

1. The value should remain constant under all conditions.
2. The mutual inductance should not vary with temperature.
3. The inductance should be independent of excitation.
4. They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are

View solution

Q. For measuring current at a high frequency we should use

View solution

Q. A moving iron instrument can be used for dc as well as ac.

View solution

Q. Two wattmeter method of 3-phase power measurement can be used to find

View solution