Question
a.
unit change in resistance per unit change in length
b.
change in resistance per unit change in length
c.
unit change in length per unit change in resistance
d.
none of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Gauge factor of a strain gauge is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): Capacitance effect can be used to measure thickness of sheets, displacement and pressure.
Reason (R): Capacitance between two plates depends on the area of plates, distance between plates and permittivity of medium.
View solution
Q. The total insulation resistance consists of insulation volume resistance and surface leakage resistance.
View solution
Q. Assertion (A): Energy meters use induction principle.
Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.
View solution
Q. A dynamometer wattmeter can be used for
View solution
Q. The operating voltage of a megger is about
View solution
Q. An ohmmeter is a
View solution
Q. Loading effect is primarily caused by instruments having
View solution
Q. Capacitive transducer is superior to inductive type for measurement of capacitance because of
View solution
Q. Which of the following effects is used in measurement of magnetic flux?
View solution
Q. It is required to measure pressure using LVDT. The additional device needed is
View solution
Q. Which of the following quantities have same dimension in emu and esu?
1. Current
2. Electrical power
3. Electrical energy
Select the answer as per following codes
View solution
Q. In a dynamometer instrument, the moving coil is pressure coil.
View solution
Q. Load cell uses
View solution
Q. Assertion (A): A dc potentiometer measures the true open circuit emf of a source.
Reason (R): At balance point, a dc potentiometer does not draw any current from the source.
View solution
Q. In a CRO the Y plates are oriented
View solution
Q. The accuracy of an instrument is determined by
View solution
Q. If σ standard deviation, probable error
View solution
Q. Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.
Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.
View solution
Q. In a megger the moving coil meter has a permanent magnet.
View solution
Q. The accuracy of a multimeter is about
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
