Q. In a CE amplifier the collector resistance is short circuited. The ac output voltage will

View solution

Q. In a transistor CE mode, VCC = +30 V. If the transistor is in cut off region, VCE =

View solution

Q. The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is

View solution

Q. An integrating amplifier has resistance in feedback path.

View solution

Q. Values of VT at 20°C for an ideal P-N diode

View solution

Q. Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

View solution

Q. A negative feedback can be of

View solution

Q. In a class C power amplifier the input frequency of ac signal is 1 MHz. If tank circuit has C = 1000 pF, the value of L =

View solution

Q. In calculating output impedance of an amplifier the source is replaced by an open circuit.

View solution

Q. For transistor 2 N 338 the manufacturer specifies Pmax = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is

View solution

Q. A 120 V, 30 Hz source feeds a half wave rectifier circuit through a 4 : 1 step down transformer, the average output voltage is

View solution

Q. The slew rate of an ideal op-amp is

View solution

Q. Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω

View solution

Q. Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

View solution

Q. A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is

View solution

Q. The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be

View solution

Q. In an RC phase shift oscillator, the total phase shift of the three RC lead networks is

View solution

Q. It has been found that in a rectifier circuit with RC filter one RC section reduces ripple by 15%. Two RC sections are used in cascade the reduction in ripple would be

View solution

Q. An op-amp has

View solution

Q. As the ratio Rf/RL increases the efficiency of a rectifier increases.

View solution