Q. Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω

View solution

Q. Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

View solution

Q. A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is

View solution

Q. The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be

View solution

Q. In an RC phase shift oscillator, the total phase shift of the three RC lead networks is

View solution

Q. It has been found that in a rectifier circuit with RC filter one RC section reduces ripple by 15%. Two RC sections are used in cascade the reduction in ripple would be

View solution

Q. An op-amp has

View solution

Q. As the ratio Rf/RL increases the efficiency of a rectifier increases.

View solution

Q. If the Q of a single stage single tuned amplifier is doubled, the bandwidth will

View solution

Q. In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is

View solution

Q. The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?

View solution

Q. In a CE amplifier circuit the ac voltage between emitter and ground

View solution

Q. A CE amplifier has re = 6 Ω, β = 100 and a = 0.98. The input impedance is

View solution

Q. A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulation is

View solution

Q. Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has ICBO = 400 nA at 25°C, then its leakage current at 80°C

View solution

Q. A CB amplifier has IE = 3.5 mA, a = 0.98 and RL = 600 Ω. The input impedance

View solution

Q. An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are

View solution

Q. In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is

View solution

Q. In a CE amplifier circuit the dc voltage between emitter and ground

View solution

Q. A buffer amplifier should have

View solution