Question
a.
20%
b.
50%
c.
100%
d.
200%
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has ICBO = 400 nA at 25°C, then its leakage current at 80°C
View solution
Q. A CB amplifier has IE = 3.5 mA, a = 0.98 and RL = 600 Ω. The input impedance
View solution
Q. An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
View solution
Q. In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is
View solution
Q. In a CE amplifier circuit the dc voltage between emitter and ground
View solution
Q. A buffer amplifier should have
View solution
Q. If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
View solution
Q. An npn transistor has a Beta cutoff frequency fβ of 1 MHz, and a common emitter short circuit low frequency current gain β0 of 200. It unity gain frequency fT and the alpha cut off frequency fa2 respectively are
View solution
Q. If input frequency is 50 Hz, the frequency of output wave in a full wave diode rectifier circuit is
View solution
Q. A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
View solution
Q. A half wave diode rectifier uses a diode having forward resistance of 50 ohms. The load resistance is also 50 ohms. Then the voltage regulation is
View solution
Q. A Hartley oscillator is used for
View solution
Q. In Class C operation the collector current looks like
View solution
Q. An op-amp integrating circuit uses
View solution
Q. Which of the following can be used as a buffer amplifier?
View solution
Q. A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency fOH with a second order HP filter having lower cut off frequency fOL provided
View solution
Q. The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about
View solution
Q. A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
View solution
Q. The main advantage of CC amplifier is
View solution
Q. If a = 0.995, IE = 10 mA, ICO = 0.5 mA, then ICEO will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!