Q. If a = 0.995, IE = 10 mA, ICO = 0.5 mA, then ICEO will be

View solution

Q. Assertion (A): In class C amplifier the efficiency is more than that for other classes of amplifiers

Reason (R): In class C amplifier we can get high efficiency over a wideband

View solution

Q. Heat sink results in

View solution

Q. A buffer amplifier should have

View solution

Q. In a CE amplifier, the output voltage is equal to product of

View solution

Q. A diode can have a very high forward resistance.

View solution

Q. An increase in ambient temperature means that maximum power rating of transistor

View solution

Q. Two CE stages are coupled through a capacitor. To calculate the quiescent base current of the two transistors, the capacitor is treated as

View solution

Q. If it is desired to have low output impedance in an amplifier circuit then we should use

View solution

Q. Generally the gain of a transistor amplifier falls at high frequencies due to the

View solution

Q. A transistor with a = 0.9 and ICBO = 10 μA is biased so that IBQ = 90 μA. Then ICQ will be

View solution

Q. A CB amplifier has a = 0.98 and RL = 600 Ω. If IE = 3.5 mA, the current gain is

View solution

Q. funity of an op-amp is about 1 kHz.

View solution

Q. Assertion (A): In an RC coupled amplifier the junction capacitances can be neglected at low frequencies but not at high frequencies

Reason (R): Capacitive reactance is inversely proportional to frequency.

View solution

Q. In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is

View solution

Q. A class C amplifier has input frequency of 200 kHz. If width of collector pulses is 0.1 μs, duty cycle is

View solution

Q. Output of a phase splitter is

View solution

Q. In a transistor the minimum and maximum values of βdc are 100 and 121. The proper value of βdc to be used to locate Q point is

View solution

Q. The input to an op-amp integrating amplifier is a constant voltage. The output will be

View solution

Q. FET amplifier is more difficult to analyse than BJT amplifier.

View solution