Q. Output of a phase splitter is

View solution

Q. In a transistor the minimum and maximum values of βdc are 100 and 121. The proper value of βdc to be used to locate Q point is

View solution

Q. The input to an op-amp integrating amplifier is a constant voltage. The output will be

View solution

Q. FET amplifier is more difficult to analyse than BJT amplifier.

View solution

Q. If an amplifier with gain of - 100 and feedback of β = - 0.1 has a gain change of 20% due to temperature the change in gain of the feedback amplifier will be

View solution

Q. A voltage gain of a CE amplifier connected in collector to base configuration is 50. Collector to base resistor RF = 1 kΩ, RC = 4Ω, the O/P resistance R0 =?

View solution

Q. A voltage multiplier circuit, using diodes and capacitors is suitable for

View solution

Q. In a CE amplifier the ac emitter resistance

View solution

Q. The output impedance of an ideal op-amp is

View solution

Q. A virtual ground is a ground for

View solution

Q. As compared to a full wave diode rectifier circuit using centre tapped transformer, the bridge diode rectifier circuit has the main advantage of

View solution

Q. To bypass a 100 ohm emitter resistor at

View solution

Q. In a CE amplifier the dc load line is the same as ac load line when

View solution

Q. If the output current wave shape of class C circuit has a period of 1 μs and a pulse width of 0.006 μs, the duty cycle is

View solution

Q. Which configuration is suitable for impedance matching?

View solution

Q. A BJT is said to be operating in saturation region if

View solution

Q. Which component is allowed to pass through it by a choke filter?

View solution

Q. In an amplifier the stray capacitances assume impedance at low frequencies

View solution

Q. In CE amplifier the base current is very high.

View solution

Q. In the graphical analysis of CE amplifier circuit, the upper end of load line is called

View solution