Question

A BJT is said to be operating in saturation region if

a.

both junctions are reverse biased

b.

both junctions are forward biased

c.

base emitter junction is forward biased and base collector junction is reverse biased

d.

base collector junction is forward biased and base emitter junction is reverse biased

Answer: (b).both junctions are forward biased

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A BJT is said to be operating in saturation region if

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which component is allowed to pass through it by a choke filter?

Q. In an amplifier the stray capacitances assume impedance at low frequencies

Q. In CE amplifier the base current is very high.

Q. In the graphical analysis of CE amplifier circuit, the upper end of load line is called

Q. A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage

Q. Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)

Q. In a capacitor filter, the time constant RLC should be small.

Q. A 741 type op-amp has a gain bandwidth product of 1 MHz. A non-inverting amplifier using this op-amp and having a voltage gain of 20 dB will exhibit a -3dB bandwidth of

Q. In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is

Q. In the graphical analysis of an amplifier circuit, the slope of dc load line depends on

Q. In a self bias circuit for CE amplifier, an increase in emitter resistance RE results in

Q. For a BJT if β = 50, ICEO = 3 μA and IC = 1.2 mA then IE

Q. When the circuit is switched on, the loop gain of a Wien bridge oscillator is

Q. The input to integrating op-amp is a rectangular wave. The output will be

Q. The most widely used diode rectifier circuit is

Q. The main advantage of a crystal oscillator

Q. Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C

Q. A voltage tripler circuit and voltage quadrupler circuit use identical components. Then

Q. A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, VD is found to be 0.3 V. If VD = 0.4 V then forward current will be

Q. In a power amplifier the collector current flows for 270° of the input cycle. The operations is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!