Question

The input to integrating op-amp is a rectangular wave. The output will be

a.

a sine wave

b.

a rectangular wave

c.

a triangular wave

d.

none of the above

Answer: (c).a triangular wave

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The input to integrating op-amp is a rectangular wave. The output will be

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The most widely used diode rectifier circuit is

Q. The main advantage of a crystal oscillator

Q. Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C

Q. A voltage tripler circuit and voltage quadrupler circuit use identical components. Then

Q. A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, VD is found to be 0.3 V. If VD = 0.4 V then forward current will be

Q. In a power amplifier the collector current flows for 270° of the input cycle. The operations is

Q. An amplifier has input impedance of 4 kΩ and output impedance of 80 kΩ. It is used in negative feedback circuit with 10% feedback. If open loop gain is 90, the closed loop input and output impedances are

Q. In a negative feedback amplifier A = 100, β = 0.04 and Vs = 50 mV, then feedback will be

Q. A voltage doubler circuit is fed by a voltage Vm sin ωt. The output voltage will be nearly 2 Vm only if

Q. The purpose of connecting a coupling capacitor in the output circuit of an amplifier is

Q. A full wave rectifier circuit using centre tapped transformer, the input frequency 50 Hz. The frequency of output is

Q. If the midband gain of an amplifier is 40 dB, the gain at half power frequency is

Q. It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are

Q. An ideal op-amp requires

Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?

Q. The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of

Q. An inverting amplifier has R1 = 10 kΩ, and Rf = 150 kΩ then the O/P voltage, if input voltage Vi = 1 volt.

Q. Consider the following statements:

A totem pole configuration used in the output stage if an op-amp has the advantage of using

1. Only n-p-n BJTs
2. Complementary symmetrical pair of transistors
3. Only one transistor

Which of these statements is/are correct?

Q. Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

Q. The most common method for biasing a JFET is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!