Question
a.
half wave
b.
full wave with centre tapped transformer
c.
bridge
d.
either (a) or (b)
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The most widely used diode rectifier circuit is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The main advantage of a crystal oscillator
View solution
Q. Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
View solution
Q. A voltage tripler circuit and voltage quadrupler circuit use identical components. Then
View solution
Q. A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, VD is found to be 0.3 V. If VD = 0.4 V then forward current will be
View solution
Q. In a power amplifier the collector current flows for 270° of the input cycle. The operations is
View solution
Q. An amplifier has input impedance of 4 kΩ and output impedance of 80 kΩ. It is used in negative feedback circuit with 10% feedback. If open loop gain is 90, the closed loop input and output impedances are
View solution
Q. In a negative feedback amplifier A = 100, β = 0.04 and Vs = 50 mV, then feedback will be
View solution
Q. A voltage doubler circuit is fed by a voltage Vm sin ωt. The output voltage will be nearly 2 Vm only if
View solution
Q. The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
View solution
Q. A full wave rectifier circuit using centre tapped transformer, the input frequency 50 Hz. The frequency of output is
View solution
Q. If the midband gain of an amplifier is 40 dB, the gain at half power frequency is
View solution
Q. It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
View solution
Q. An ideal op-amp requires
View solution
Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
View solution
Q. The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of
View solution
Q. An inverting amplifier has R1 = 10 kΩ, and Rf = 150 kΩ then the O/P voltage, if input voltage Vi = 1 volt.
View solution
Q. Consider the following statements:
A totem pole configuration used in the output stage if an op-amp has the advantage of using
1. Only n-p-n BJTs
2. Complementary symmetrical pair of transistors
3. Only one transistor
Which of these statements is/are correct?
View solution
Q. Assertion (A): An op-amp amplifier can amplify dc signal
Reason (R): An op-amp amplifier is a direct coupled amplifier
View solution
Q. The most common method for biasing a JFET is
View solution
Q. The h parameter equivalent circuit of BJT has one voltage source and one current source.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!