Q. It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are

View solution

Q. An ideal op-amp requires

View solution

Q. A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?

View solution

Q. The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of

View solution

Q. An inverting amplifier has R1 = 10 kΩ, and Rf = 150 kΩ then the O/P voltage, if input voltage Vi = 1 volt.

View solution

Q. Consider the following statements:

A totem pole configuration used in the output stage if an op-amp has the advantage of using

1. Only n-p-n BJTs
2. Complementary symmetrical pair of transistors
3. Only one transistor

Which of these statements is/are correct?

View solution

Q. Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

View solution

Q. The most common method for biasing a JFET is

View solution

Q. The h parameter equivalent circuit of BJT has one voltage source and one current source.

View solution

Q. In an RC-coupled amplifier for improving the low frequency response

View solution

Q. The minimum gate source voltage that creates the n-type inversion layer is called

View solution

Q. At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as

View solution

Q. An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?

View solution

Q. If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be

View solution

Q. An ideal voltage amplifier should have

View solution

Q. In a class C operation VCC = 40 V, RL = 50 Ω. The maximum load power can be

View solution

Q. IF VCC = 15 V, VCEQ = 5 V and ICQ = 50 mA, the efficiency in class A operation is

View solution

Q. A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is

View solution

Q. Which of the following best represents the bandwidth of an actual op-amp?

View solution

Q. Class C amplifier is suitable for

View solution