Q. The h parameter equivalent circuit of BJT has one voltage source and one current source.

View solution

Q. In an RC-coupled amplifier for improving the low frequency response

View solution

Q. The minimum gate source voltage that creates the n-type inversion layer is called

View solution

Q. At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as

View solution

Q. An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?

View solution

Q. If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be

View solution

Q. An ideal voltage amplifier should have

View solution

Q. In a class C operation VCC = 40 V, RL = 50 Ω. The maximum load power can be

View solution

Q. IF VCC = 15 V, VCEQ = 5 V and ICQ = 50 mA, the efficiency in class A operation is

View solution

Q. A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is

View solution

Q. Which of the following best represents the bandwidth of an actual op-amp?

View solution

Q. Class C amplifier is suitable for

View solution

Q. In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in

View solution

Q. A Wien bridge is suitable for

View solution

Q. Which op-amp circuit uses a capacitor in series with input and resistance in feedback path?

View solution

Q. For class B operation the theoretical maximum efficiency is

View solution

Q. Typical values of current gains for CE, CB and CC amplifiers are

View solution

Q. To draw ac equivalent circuit for a CE amplifier we should

View solution

Q. The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is

View solution

Q. Assertion (A): The gain of an FET amplifier can be changed by changing gm

Reason (R): Most receivers use automatic gain control to counteract changes in volume caused by fading

View solution