Q. A Wien bridge is suitable for

View solution

Q. Which op-amp circuit uses a capacitor in series with input and resistance in feedback path?

View solution

Q. For class B operation the theoretical maximum efficiency is

View solution

Q. Typical values of current gains for CE, CB and CC amplifiers are

View solution

Q. To draw ac equivalent circuit for a CE amplifier we should

View solution

Q. The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is

View solution

Q. Assertion (A): The gain of an FET amplifier can be changed by changing gm

Reason (R): Most receivers use automatic gain control to counteract changes in volume caused by fading

View solution

Q. The element in the feedback circuit of a logarithmic amplifier using op-amp is

View solution

Q. In a FET, gm varies as

View solution

Q. Assertion (A): Class A and Class B amplifier predominate in audio applications.

Reason (R): Class C amplifier is used at radio frequencies.

View solution

Q. For an ideal noise free transistor amplifier the noise factor is

View solution

Q. In a crystal

View solution

Q. Ultra high frequency oscillators work in the range

View solution

Q. N-channel FETs are superior to p-channel FETs because

View solution

Q. It is desired to reduce distortion in a CE amplifier circuit. We should

View solution

Q. For a push pull circuit the most favoured biasing method is

View solution

Q. In feedback amplifier the closed loop gain is nearly independent of open loop gain and depends only on the feedback factor.

View solution

Q. In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in

View solution

Q. Transformer coupling is mostly used in

View solution

Q. Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?

View solution