Q. In a FET, gm varies as

View solution

Q. Assertion (A): Class A and Class B amplifier predominate in audio applications.

Reason (R): Class C amplifier is used at radio frequencies.

View solution

Q. For an ideal noise free transistor amplifier the noise factor is

View solution

Q. In a crystal

View solution

Q. Ultra high frequency oscillators work in the range

View solution

Q. N-channel FETs are superior to p-channel FETs because

View solution

Q. It is desired to reduce distortion in a CE amplifier circuit. We should

View solution

Q. For a push pull circuit the most favoured biasing method is

View solution

Q. In feedback amplifier the closed loop gain is nearly independent of open loop gain and depends only on the feedback factor.

View solution

Q. In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in

View solution

Q. Transformer coupling is mostly used in

View solution

Q. Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?

View solution

Q. The current ICBO flows in

View solution

Q. The h parameter h11 is the same in CE and CC circuit.

View solution

Q. A second-order band-pass active filter can be obtained by cascading a low pass second order section having cut off frequency fOH with a high pass second order section having cut-off frequency fOL provided

View solution

Q. A sine wave is passed through an amplifier which severely limits it symmetrically. If then passes to a second amplifier which is narrow band and tuned to the frequency of the original sine wave. What will be the output wave from this second amplifier?

View solution

Q. In which configuration is ac collector voltage zero?

View solution

Q. Which connection is rarely used?

View solution

Q. Assertion (A): The main use of positive feedback is in oscillator circuits.

Reason (R): In an oscillator the loop gain Aβ is kept slightly more than unity

View solution

Q. In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.

View solution