Question
a.
6%
b.
0.6%
c.
0.006%
d.
0.06%
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. If the output current wave shape of class C circuit has a period of 1 μs and a pulse width of 0.006 μs, the duty cycle is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which configuration is suitable for impedance matching?
View solution
Q. A BJT is said to be operating in saturation region if
View solution
Q. Which component is allowed to pass through it by a choke filter?
View solution
Q. In an amplifier the stray capacitances assume impedance at low frequencies
View solution
Q. In CE amplifier the base current is very high.
View solution
Q. In the graphical analysis of CE amplifier circuit, the upper end of load line is called
View solution
Q. A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
View solution
Q. Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)
View solution
Q. In a capacitor filter, the time constant RLC should be small.
View solution
Q. A 741 type op-amp has a gain bandwidth product of 1 MHz. A non-inverting amplifier using this op-amp and having a voltage gain of 20 dB will exhibit a -3dB bandwidth of
View solution
Q. In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
View solution
Q. In the graphical analysis of an amplifier circuit, the slope of dc load line depends on
View solution
Q. In a self bias circuit for CE amplifier, an increase in emitter resistance RE results in
View solution
Q. For a BJT if β = 50, ICEO = 3 μA and IC = 1.2 mA then IE
View solution
Q. When the circuit is switched on, the loop gain of a Wien bridge oscillator is
View solution
Q. The input to integrating op-amp is a rectangular wave. The output will be
View solution
Q. The most widely used diode rectifier circuit is
View solution
Q. The main advantage of a crystal oscillator
View solution
Q. Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
View solution
Q. A voltage tripler circuit and voltage quadrupler circuit use identical components. Then
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!