Question

In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is

a.

3.6

b.

36

c.

7.2

d.

72

Answer: (b).36

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a BJT amplifier the power gain from base to collector is 4000. The power gain in dB is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In a CE amplifier circuit the dc voltage between emitter and ground

Q. A buffer amplifier should have

Q. If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is

Q. An npn transistor has a Beta cutoff frequency fβ of 1 MHz, and a common emitter short circuit low frequency current gain β0 of 200. It unity gain frequency fT and the alpha cut off frequency fa2 respectively are

Q. If input frequency is 50 Hz, the frequency of output wave in a full wave diode rectifier circuit is

Q. A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than

Q. A half wave diode rectifier uses a diode having forward resistance of 50 ohms. The load resistance is also 50 ohms. Then the voltage regulation is

Q. A Hartley oscillator is used for

Q. In Class C operation the collector current looks like

Q. An op-amp integrating circuit uses

Q. Which of the following can be used as a buffer amplifier?

Q. A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency fOH with a second order HP filter having lower cut off frequency fOL provided

Q. The open loop gain of an amplifier is 50 but likely to decrease by 20% due to various factors. If negative feedback with β = 0.1 is used, the change in gain will be about

Q. A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are

Q. The main advantage of CC amplifier is

Q. If a = 0.995, IE = 10 mA, ICO = 0.5 mA, then ICEO will be

Q. Assertion (A): In class C amplifier the efficiency is more than that for other classes of amplifiers

Reason (R): In class C amplifier we can get high efficiency over a wideband

Q. Heat sink results in

Q. A buffer amplifier should have

Q. In a CE amplifier, the output voltage is equal to product of

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!