Question
a.
True
b.
False
c.
May be True or False
d.
can't say
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. With negative feedback the closed loop gain is always less than open loop gain.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. As compared to a bipolar transistor, a JFET is
View solution
Q. In a bistable multivibrator, commutating capacitors are used to
View solution
Q. Which of the following values represents the open loop gain of typical op-amp?
View solution
Q. Which of the following configuration has low thermal stability?
View solution
Q. Efficiency of class A power amplifier is very poor.
View solution
Q. An ideal op-amp can amplify dc signals
View solution
Q. Consider the following statements :The lower cut off frequencies of an RC coupled amplifier depend on
1. input and output coupling capacitor
2. emitter by pass capacitors
3. junction capacitances
Which of the above are correct?
View solution
Q. Assertion (A): In a circuit using FET, gate is approximately at dc ground
Reason (R): Self bias stabilizes the quiescent operating point against changes in JFET parameters
View solution
Q. The Darlington pair consists of the following two stages
View solution
Q. A Clapp's oscillator is
View solution
Q. A quiescent state of a transistor implies
View solution
Q. A transistor may fail due to
View solution
Q. In a P-N-P transistor, with normal bias, the emitter junction
View solution
Q. The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes
View solution
Q. Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
View solution
Q. A transconductance amplifier has
View solution
Q. The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
View solution
Q. In order to protect a MOSFET against damage from any stray voltage at the gate
View solution
Q. A dc amplifier can operate
View solution
Q. Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about gm rd
Reason (R): A common source amplifier is a source follower circuit
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
