Question
a.
emitter junction is forward biased and collector junction is reverse biased
b.
emitter junction is reverse biased and collector junction is forward biased
c.
emitter junction as well as collector junction are forward biased
d.
emitter junction as well as collector junction are reverse biased
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A transistor will operate in inverted region when
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Cross-over distortion behaviour is a characteristic of
View solution
Q. The noise figure is
View solution
Q. A Darlington pair is used for
View solution
Q. In a shunt-shunt negative feedback amplifier, as compared to the basic amplifier
View solution
Q. In rectifiers the use of RC filters is recommended when
View solution
Q. The coupling capacitor mainly affects
View solution
Q. A CE amplifier is the most common BJT amplifier.
View solution
Q. The main drawback in the performance of shunt peaked wide band amplifier is
View solution
Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
View solution
Q. In a CE amplifier circuit
View solution
Q. In a push pull circuit the two transistors are
View solution
Q. In a resistance loaded amplifier, the gain decreases at high frequencies because
View solution
Q. A 1 ms pulse can be stretched to 1 sec pulse by using
View solution
Q. Most of the transistor data sheets specify the power rating for an ambient temperature of
View solution
Q. The early effect in BJT is caused by
View solution
Q. In which configuration does output ac voltage appear between emitter and ground?
View solution
Q. At high frequencies the output circuit of transistor amplifier reduces to
View solution
Q. A pulse transformer uses
View solution
Q. An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
View solution
Q. If input ac is 10 Vrms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
