Question

The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to

a.

any where

b.

a dc ground potential

c.

the most positive potential available in the circuit

d.

the most negative potential available in the circuit

Answer: (c).the most positive potential available in the circuit

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Wien bridge uses

Q. Which of the following is not necessarily the advantages of a push pull amplifier?

Q. Which of the following best represents the output impedance of an actual op-amp?

Q. The phase angle of lead circuit is

Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is

Q. The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.

Q. In CE amplifier

Q. The phase angle of a lag circuit is

Q. CMOS is widely used in

Q. A JFET can operate on

Q. Which of the following is the point of reference JFET?

Q. A Darlington pair consist of

Q. The ripple factor of a full wave rectifier is about 0.5

Q. Which of the following statement is false?

Q. The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.

Q. In a CE amplifier circuit, the output voltage

Q. Which of the following circuit would be preferred for a 355 KHz IF amplifier?

Q. In a series regulated power supply circuit, the voltage gain Av, of the 'pass' transistor satisfies the condition

Q. Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Q. The circuit consisting of two transistor connected in series with the d.c. supply voltage is called

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!