Question
a.
1.1 kHz
b.
2.5 kHz
c.
3.3 kHz
d.
6.5 kHz
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.
Reason (R): Hartley oscillator uses a tapped inductor
View solution
Q. In CB amplifier the distortion of the input voltage waveform may occur due to
View solution
Q. As compared to full wave rectifier, a half wave rectifier
View solution
Q. Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors
Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.
View solution
Q. In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
View solution
Q. A sine wave with slew rate distortion looks like
View solution
Q. If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
View solution
Q. A boot strap generally incorporates
View solution
Q. The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
View solution
Q. Power transistors are invariably provided with
View solution
Q. Assertion (A): The ac load line is different from dc load line
Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance
View solution
Q. In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is
View solution
Q. The absolute values of pinch-off voltage and gate-source cut-off voltage are
View solution
Q. Which of the following circuit does not need a coupling capacitor?
View solution
Q. Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.
Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.
View solution
Q. In case of a transistor amplifier the emitter resistance Re is removed
View solution
Q. In oscillators class C operation is preferred because
View solution
Q. In a common emitter circuit all voltages are measured with respect to
View solution
Q. The h parameter equivalent to ac resistance re is
View solution
Q. The theoretical maximum efficiency of a half wave diode rectifier is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!