Question

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

a.

Both A and R are correct and R is correct explanation for A

b.

Both A and R are correct but R is not correct explanation for A

c.

A is correct R is wrong

d.

A is wrong R is correct

Answer: (a).Both A and R are correct and R is correct explanation for A

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Assertion (A): The ac load line is different from dc load line Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is

Q. The absolute values of pinch-off voltage and gate-source cut-off voltage are

Q. Which of the following circuit does not need a coupling capacitor?

Q. Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Q. In case of a transistor amplifier the emitter resistance Re is removed

Q. In oscillators class C operation is preferred because

Q. In a common emitter circuit all voltages are measured with respect to

Q. The h parameter equivalent to ac resistance re is

Q. The theoretical maximum efficiency of a half wave diode rectifier is

Q. Which of the following statement is correct?

Q. In a transistor push pull amplifier

Q. In a self bias circuit for CE amplifier, the base voltage is

Q. A push pull amplifier is a

Q. An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. How much feedback should be used to provide the desired level?

Q. Which of the following oscillator circuits uses three capacitors in the phase shifting network?

Q. Consider the following rectifier circuits :

1. half-wave rectifier without filter
2. full-wave rectifier without filter
3. full-wave rectifier with series inductance filter
4. full-wave rectifier with capacitance filter.

The sequence of these rectifier circuits in decreasing order of their ripple factor is

Q. When a transistor is to be at a temperature above 25°C

Q. Assertion (A): In monolithic IC the components are part of one chip

Reason (R): An op-amp is a high gain dc amplifier

Q. The most widely used LC oscillator is

Q. Which of the following statement is wrong?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!