Question
a.
10 μA
b.
40 μA
c.
80 μA
d.
200 μA
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For a transistor if αdc = 0.98 and emitter current IE is 2 mA, then base current will be
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier
Reason (R): The error voltage in a feedback circuit is very small
View solution
Q. Assertion (A): The horizontal intercept of dc load line is the same as ideal cut off point
Reason (R): When a transistor is in cut off region, collector current is zero
View solution
Q. In a full wave diode rectifier circuit each diode carries current for
View solution
Q. When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
View solution
Q. The mobility of e- for Ge and Si respectively is
View solution
Q. If a capacitor C is charged by a constant current I, then the rate of change of voltage with time given by sweep speed equal to
View solution
Q. In operational Amplifier, Common mode voltage gain should be
View solution
Q. Which of the following are linear ICs?
View solution
Q. The more negative gate voltage, the conductive channel becomes
View solution
Q. Which circuit has its output signal from, the emitter?
View solution
Q. A JFET is a
View solution
Q. When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
View solution
Q. For full wave rectification four diode bridge rectifier is claimed to have following advantages:
1. Less expensive transformer
2. Small size transformer
3. Suitable for higher voltage applications
Which of these are correct?
View solution
Q. Which class of amplifiers operates with least distortion?
View solution
Q. Which configuration has high input impedance and low output impedance?
View solution
Q. Assertion (A): An ac amplifier uses coupling capacitors at input and output
Reason (R): The capacitive reactance varies inversely with frequency. It is infinite for dc
View solution
Q. Common base configuration is little used because
View solution
Q. If the plate supply voltage for a plate modulated class C amplifier is E volts, the maximum plate-cathode voltage could be almost as high as
View solution
Q. The changes in ambient temperature affect the open loop gain of amplifier.
View solution
Q. In a JFET, the lower end is called the __________ and the upper end is called the __________ .
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!