Question

For input and later stages, BI-FET op-amp use

a.

JFETs and MOSFETs respectively

b.

MOSFETs and JFETs respectively

c.

JFETs and BJTs respectively

d.

BJTs and JFETs respectively

Answer: (c).JFETs and BJTs respectively

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. For input and later stages, BI-FET op-amp use

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage Vid only when the magnitude of Vid is less a times the thermal voltage, where α is

Q. In most transistor the collector region is made physically larger than the emitter region

Q. The leakage current in CB configuration may be around

Q. In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in

Q. Class-B amplifier has less efficiency compared to

Q. Calculate the O/P voltage of a non-inverting constant gain multiplier with R1 = 100 kΩ, Rf= 600 kΩ, V1 = 2 volt, then O/P voltage Vo of non inverting op-amp is given by

Q. Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?

Q. Saturation of iron core causes distortion.

Q. Which of the following is non-sinusoidal oscillator?

Q. Low gain-bandwidth product of a JFET is due to

Q. In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be

Q. In a base driver amplifier the voltage gain is the ratio of

Q. Assertion (A): A class C amplifier is a timed amplifier which needs a tank circuit as the load in the collector circuit of the transistor for its proper operation

Reason (R): In class C operation collector current flows for less than 180° of the ac cycle and thus flows in pulses

Q. A junction Field Effect Transistor can operate in

Q. In the case of an amplifier, the normalised voltage gain is given by.where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,

Q. In a rectifier only a portion of input power is converted into DC power. The rest is AC power.

Q. The slope of the transfer characteristics of an N-channel JFET is

Q. In a current mirror

Q. In which of the following circuits is op-amp used in open loop configuration?

Q. In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!