Q. Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?

View solution

Q. Saturation of iron core causes distortion.

View solution

Q. Which of the following is non-sinusoidal oscillator?

View solution

Q. Low gain-bandwidth product of a JFET is due to

View solution

Q. In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be

View solution

Q. In a base driver amplifier the voltage gain is the ratio of

View solution

Q. Assertion (A): A class C amplifier is a timed amplifier which needs a tank circuit as the load in the collector circuit of the transistor for its proper operation

Reason (R): In class C operation collector current flows for less than 180° of the ac cycle and thus flows in pulses

View solution

Q. A junction Field Effect Transistor can operate in

View solution

Q. In the case of an amplifier, the normalised voltage gain is given by.where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,

View solution

Q. In a rectifier only a portion of input power is converted into DC power. The rest is AC power.

View solution

Q. The slope of the transfer characteristics of an N-channel JFET is

View solution

Q. In a current mirror

View solution

Q. In which of the following circuits is op-amp used in open loop configuration?

View solution

Q. In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is

View solution

Q. In deriving ac equivalent circuit for an amplifier circuit we short circuit

View solution

Q. Which of the following statements is false?

View solution

Q. Which of the following amplifier circuit using junction transistor has the best gain?

View solution

Q. In an op-amp differentiator

View solution

Q. In switching devices, gold doping is used to

View solution

Q. Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

View solution