Q. In a broadcast superheterodyne receiver

View solution

Q. A duplexer is a device used to

View solution

Q. A heterodyne frequency changer is called a

View solution

Q. RF amplifiers are used in radio receivers for

View solution

Q. An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10¯⁵ ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is

View solution

Q. The output of a diode detector contains

View solution

Q. Which of the following noise does not occur in transistors?

View solution

Q. Noise generated in a resistor is also known as

View solution

Q. Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?

View solution

Q. The noise generated by a resistor depends upon

View solution

Q. In a superheterodyne receiver

View solution

Q. The function of an AM detector circuit is to

View solution

Q. Which of the following should be used in order to prevent overloading or the last IF amplifier in a receiver?

View solution

Q. Most popular IF for receivers tuning to 540 to 1650 kHz is

View solution

Q. In superheterodyne receivers, the local oscillator is used to

View solution

Q. Which of the following is same in AM and FM receivers?

View solution

Q. A notch filter is sometimes used in communication receivers to

View solution

Q. Which one of the following is not a useful quantity for comparing the noise performance of receivers?

View solution

Q. Which of the following statement about the amplitude limiter is not valid?

View solution

Q. In a radio receiver, if the intermediate frequency is too low

View solution